Released 23/01/2025 - Previous version 5.435
Please note this firmware release only applies to the eddi v2.1 with built in Ethernet, WiFi and "vHub". These eddis have a serial number starting with a "2" or higher
It does not apply to previous versions of eddi without the built in WiFi/Ethernet.
Key Updates
Improved eddi+ Compatibility
- eddi 2.1 now integrates seamlessly with eddi+, ensuring optimal performance.
Enhanced Dual Heater Operation
- Outputs set to "None" will no longer activate unnecessarily, preventing energy waste.
- Manual boosts are improved: prioritise which heater runs first and easily check boost durations.
- Bug fixes ensure better stability when using dual heaters.
Heat Battery Icon & State
- A new Heat Battery icon now displays when maximum temperature is reached.
- eddi 2.1 will maintain heat for up to 60 minutes after reaching max temperature.
- The Heat Battery state will only re-engage after 30 days or another max temperature cycle.
Temperature Safety Cut-Off
- If a PT1000 sensor detects temperatures above 93°C for over 3 seconds, eddi 2.1 will trip for safety.
- Resetting can be done quickly via an on-screen prompt.
General Improvements
G100 Communication Enhancements
- Improved server messaging and algorithm refinements for smoother G100 operation.
Smarter Temperature Limits
- The "Grid Temperature Limit" can no longer exceed the "Generation Temperature Limit."
- Any surplus energy will divert to the Generation Temperature Limit when required.
Lower Minimum Temperature Setting
- PT1000 sensors can now be set as low as 10°C.
Translation Updates
- Improved German translations for a better user experience.
Information Display Enhancements
- G100-enabled systems now display their status directly on the master eddi 2.1 info screen.
Bug Fixes
5.458 - Hotfix
- Resolved an issue with three-phase systems in the installation assistant affecting phase settings.
- Fixed relay bugs impacting manual boosts and transitions between scheduled/manual boosts.
- Corrected G100 timestamp log reset issues.
- Smoothed out UI issues when exiting linked device menus.
- Improved text labels for external CTs to enhance clarity.
- Fixed a display issue with consumption power readings.
- Improved recovery process for devices with corrupted MAC or Serial addresses.