Released 21/08/2022- Previous version 3.171
Please note this firmware release is for the original zappi 2.0.
It does not apply to zappi with built in WiFi/Ethernet.
Before upgrading the zappi please ensure that your hub also has version 3.051 firmware or above installed
Instructions on how to update the firmware on your zappi and other myenergi devices can be found
-> here <-
The PWM signal could have been turned ON briefly during Stop mode. This happened if there was a scheduled charge set but zappi is in STOP mode. The Kia EV6 responded to this signal and would wake up the onboard electronics.
- Over/Under Voltage Fault status sent to the server wasn’t cleared when voltage level came back to normal. This caused the app to crash
- ChargeGreen% in eventlogs fix (only available on the local display at the moment - Green % will be available on myaccount in the future)
- Timezones can now be selected in the right order and the display matches the time offset to be applied (affects Australian and New Zealand timezones)
3.175: Hot Fix to resolve an issue with the radio frequency when AEST/AESTT timezone selected.