Released W/C 24/04/25
Please Note
This firmware release only applies to the eddi+ with built in Ethernet, Wi-Fi and "vHub". These eddis have a serial number starting with a "2" or higher.
It does not apply to previous versions of eddi without the built in Wi-Fi/Ethernet.
Key Updates
Key Features
- For additional safety, the device will now trip when a PT1000 sensor detects a temperature above 93°C for more than 3 seconds. You will see a screen prompt so you can reset it safely.
- You can now choose which outputs are active via advanced settings. If you deactivate an output, eddi+ will no longer try to power it.
General Improvements
- Improved communications between eddi+ and servers about G100 information.
- Fixed an issue where G100 lockouts couldn’t be reset if the device lost track of the date and time.
- Safeguard introduced so “Grid Temperature Limit” cannot be set higher than the “Generation Temperature Limit”.
- Fine-tuned how eddi+ calculates whether outputs are unbalanced, for more reliable operation.
- You can now set PT1000 sensors as low as 10°C, giving you more control over your heating setup
Bug Fixes
- Removal of the ability to set a device limit.
- German language fixes.