Released W/C 16/06/25
Please Note
This firmware release only applies to the eddi+ with built in Ethernet, Wi-Fi and "vHub". These eddis have a serial number starting with a "2" or higher
It does not apply to previous versions of eddi without the built in Wi-Fi/Ethernet.
Key Updates
New Features
- German fault codes will now be displayed.
- When a device checks for updated firmware it should perform a DNS lookup of the firmware server IP address.
- Implementation of a brute force mechanism for the Installer Pincode. The eddi will be locked for 1 minute after 3 incorrect pins have been entered
- Add Support of radio legacy mode. This change will stop devices transmitting/receiving packets over RF when legacy mode is disabled.
- Amended "Linked Devices" menu, introduction of "Comms Settings" entry & support of "Legacy Mode"
- Significant improvement on Minute Data Handling.
General Improvements
None
Bug Fixes
- Fixed an issue related to vHub features where devices could freeze or trigger NMI faults.
- eSense boost energy is displayed correctly on the app.