Safely Powering Down and Rebooting Your Libbi Battery System

If advised by myenergi Tech Support or indicated by a fault code instruction, follow the steps below to safely power down and reboot your Libbi battery system.

Emergency Power Down Procedure

  1. Isolate the Controller.
  2. Open the Cable Box Cover: Unscrew the two thumb screws to access the switch box.
  3. Turn Off the Battery Switch.
  4. Turn off AC isolator
  5. Turn off PV switch on libbi, if connected.
  6. Press and Hold ALL Power Buttons: Do this on the front of the battery or batteries.
  7. Turn off DC switch on the side of the battery.

Note: To power libbi up, complete the same process in reverse. 

Rebooting the Battery
  1. Open the Cable Box Cover: Unscrew the two thumb screws to access the switch box.
  2. Turn Off the Battery Switch.
  3. Turn Off the Switch on the Side of the Battery: If your system has more than one battery, turn off all batteries.
  4. Press and Hold ALL Power Buttons: Do this on the front of the battery or batteries.
  5. Wait for 30 Seconds.
  6. Turn On the Switch on the Side of the Battery: If your system has more than one battery, turn on all batteries.
  7. Turn On the Battery Switch in the Wiring Box.

Note: If issues persist after rebooting, please contact myenergi Support for further assistance.

 

Note: Following these steps will ensure the safe handling of your Libbi battery system during power-down and reboot procedures.

 

Was this article helpful?

Have more questions? Submit a request

Related articles