Configuration
Installing multiple zappis on one site: pairing, load management and phase balancing
This guide is for installers. It covers how to pair multiple myenergi devices into one eco-system, how load balancing...
Pairing Devices
Set up your eco-system
Pair your products. Get them working to...
Changing radio frequency on myenergi devices
myenergi devices use radio frequency (RF) to communicate and pair with one another. Different regions require differe...
Off-Grid EV Charging with zappi & eddi | Installation Guide
Important myenergi products are designed for grid-connected systems and are not officially supported for off-grid us...
How to Update Firmware on a Zappi 2.0 or Eddi V1 with an Installed Ethernet Adapter
When upgrading the firmware on a zappi 2.0 or eddi V1 that has an Ethernet adapter board installed, the process ...
Correct Installation of Current Transformers (CTs) in a Three-Phase System
Introduction
For single-phase and three-phase systems, the installation of CTs differs slightly:
Single-phase zap...
What is Compatibility Mode?
Overview
Although all EVs should comply fully with the international standard, IEC 61851-1, a few have quirks that ma...